--- doc/encoders.texi.orig	2025-05-17 13:52:31 UTC
+++ doc/encoders.texi
@@ -1754,28 +1754,15 @@ Set the operating point tier.
 @item tier
 Set the operating point tier.
 
-@item rc
-Set the rate control mode to use.
-
-Possible modes:
-@table @option
-@item cqp
-Constant quantizer: use fixed values of qindex (dependent on the frame type)
-throughout the stream.  This mode is the default.
-
-@item vbr
-Variable bitrate: use a target bitrate for the whole stream.
-
-@item cvbr
-Constrained variable bitrate: use a target bitrate for each GOP.
-@end table
-
 @item qmax
 Set the maximum quantizer to use when using a bitrate mode.
 
 @item qmin
 Set the minimum quantizer to use when using a bitrate mode.
 
+@item crf
+Constant rate factor value used in crf rate control mode (0-63).
+
 @item qp
 Set the quantizer used in cqp rate control mode (0-63).
 
@@ -1786,14 +1773,18 @@ Set number of frames to look ahead (0-120).
 Set number of frames to look ahead (0-120).
 
 @item preset
-Set the quality-speed tradeoff, in the range 0 to 8.  Higher values are
-faster but lower quality.  Defaults to 8 (highest speed).
+Set the quality-speed tradeoff, in the range 0 to 13.  Higher values are
+faster but lower quality.
 
 @item tile_rows
 Set log2 of the number of rows of tiles to use (0-6).
 
 @item tile_columns
 Set log2 of the number of columns of tiles to use (0-4).
+
+@item svtav1-params
+Set SVT-AV1 options using a list of @var{key}=@var{value} pairs separated
+by ":". See the SVT-AV1 encoder user guide for a list of accepted parameters.
 
 @end table
 
--- libavcodec/version.h.orig	2025-05-17 13:52:31 UTC
+++ libavcodec/version.h
@@ -168,5 +168,8 @@
 #ifndef FF_API_INIT_PACKET
 #define FF_API_INIT_PACKET         (LIBAVCODEC_VERSION_MAJOR < 60)
 #endif
+#ifndef FF_API_SVTAV1_OPTS
+#define FF_API_SVTAV1_OPTS         (LIBAVCODEC_VERSION_MAJOR < 60)
+#endif
 
 #endif /* AVCODEC_VERSION_H */
